What to do if AEG LAVAMAT W 1270 is not spinning properly and water is still visible in the drum?
If your AEG washer isn't spinning correctly and water remains in the drum, check the drain hose for any kinks and remove them. If you have a siphon connection, ensure the siphon is not blocked and clean it. If the circulation pump is blocked, switch off the machine, unplug it from the mains, and then clean the circulation pump.
What to do if the AEG LAVAMAT W 1270 Washer door won't open?
If the door of your AEG Washer is locked, it might be for safety reasons. Wait 1-2 minutes after the program has ended, and then try opening the door again.
What to do if the AEG Washer does not take in water?
If your AEG Washer isn't taking in water, first ensure that the water tap is open. Also, check the sieve in the threaded fitting on the water inlet hose for blockages. If blocked, unscrew the hose from the tap, remove the sieve, and clean it under running water.
What to do if water cannot be completely pumped out of the AEG LAVAMAT W 1270 Washer?
If water isn't completely pumping out of your AEG Washer, check the drain hose for any kinks and remove them if necessary. Clean the circulation pump and remove any foreign bodies from the pump housing.
What to do if water runs out from under the AEG Washer?
If you notice water leaking from your AEG Washer, several factors could be the cause. Make sure to tighten the water inlet hose. Inspect the drain hose for leaks and replace it if needed. Ensure the circulation pump cover is properly closed. Also, check that no washing is trapped in the door; if so, stop the program, remove the trapped items, and start a new program.
What to do if the AEG Washer vibrates during operation or is unstable?
If your AEG Washer vibrates excessively or is unstable during operation, adjust the height adjustable threaded feet according to the installation and connection instructions.
Why AEG LAVAMAT W 1270 Washer has excessive foaming during the main wash?
Excessive foaming during the main wash in your AEG Washer is probably due to using too much detergent. Make sure to dose the detergent exactly as instructed by the manufacturer.
What to do if the AEG Washer door is not closed properly?
If the door of your AEG Washer is not closing properly, ensure you close the door firmly so that the lock engages audibly.
Why softener is not washed in AEG Washer?
If the softener isn't being washed in and the compartment for the conditioner is full of water in your AEG Washer, the suction cap in the compartment for the conditioner may not be correctly positioned or is blocked. Clean the detergent drawer and firmly place the suction cap in position.
Why is the rinse water cloudy in my AEG LAVAMAT W 1270?
Cloudy rinse water in your AEG Washer is probably due to using a detergent with a high silicate content. This has no negative impact on the rinsing results; however, you could try using a liquid detergent.
General| Model | LAVAMAT W 1270 |
|---|---|
| Capacity | 7 kg |
| Spin Speed | 1200 RPM |
| Energy Efficiency Class | A+++ |
| Load Capacity | 7 kg |
| Child Lock | Yes |
| Type | Front-loading washing machine |
| Programs | Cottons, Synthetics, Delicates, Wool, Quick Wash |
| Delay Start | Yes |
To Next Page