If the ProSense System has
completed and the water
filling has already started,
the new programme starts
without repeating the
ProSense System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
12.11 Opening the door -
Adding garments
While a programme or the delay start
operates, the appliance door is locked.
If the temperature and level
of the water in the drum are
too high and/or the drum still
rotates you cannot open the
door.
You can easily open the door for adding
or removing some items when the icon
is lighted on.
1. Touch the Start / Pause button.
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start /
Pause button.
The programme or the delay start
continues.
When the icon goes off, the door can
be opened when the programme is
complete. You may also set a spinning or
draining programme/option and than
press Start / Pause
button. If the spin
and drain programmes are not available
in the programme dial, they can be set
via App.
12.12 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
The indicator of the Start / Pause
button goes off.
The door unlocks and the indicator
goes off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
12.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The time area shows and the
display shows the door locked
.
• The indicator of the Start / Pause
button starts flashing.
• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
ENGLISH 37
To Next Page
Loading...
