• Position A for powder detergent (factory
setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid
detergents.
• Do not put more liquid then the
maximum level.
• Do not set the delay start function.
11.5 Setting a programme
1. Turn the programme knob. The related
programme indicator comes on.
The indicator of button Start/Pause
flashes with red colour.
The display shows the default temperature,
the spin speed and the empty indicator bars
of the available functions.
2. To change the temperature and/or the
spin speed, press the related buttons.
3. Set the available functions.
11.6 Starting a programme without
the delay start
Press button Start/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the lid is locked. The
display show the indicator .
The drain pump can operate for a short
time when the appliance fills water.
11.7 Cycle time recalculation
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the cycle time to the laundry you have
put in the drum to have perfect
washing results in the minimum
necessary time.
• The display shows the new time
value.
11.8 Starting a programme with the
delay start
1. Press button Delay Start again and
again until the display shows the number
of minutes or hours of delay.
The related indicator comes on.
2. Press button Start/Pause .
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button Start/Pause
to start the appliance, you can cancel or
change the set of the delay start.
11.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Delay Start
repeatedly
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
11.10 Interrupting a programme and
changing a option
You can change only some options before
they operate.
1. Press button Start/Pause .
The related indicator flashes.
2. Change the option set.
ENGLISH 23
To Next Page
