3. Press the button Start/Pause again.
The programme continues.
11.11 Cancelling a running
programme
1. Press button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press button On/Off again to activate
the appliance.
Now, you can set a new washing programme.
Before starting the new programme the
appliance could drain the water. In this
case, make sure that the detergent is still
in the detergent compartment, if not fill
the detergent again.
11.12 The ProSense load detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause button, the
maximum declared load indicator goes off,
the indicator flashes, the ProSense starts
the laundry load detection:
1. The appliance detects the load in the first
30 seconds: the indicator
and the time
dots
flash, the drum rotates shortly.
2. At the end of the load detection, the
indicator goes off and the time dots
stop flashing. The programme duration
will be adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
button to start the
programme again. The ProSense phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The ProSense detection is carried out
with complete washing programmes only
(no skipping phase selected).
The ProSense is not available with some
programmes, such as Wool/Silk,
programmes with short cycles and
without washing phase.
11.13 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the lid lock
indicator stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button On/Off
for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
To open the appliance lid:
24 ENGLISH
To Next Page
