5. Follow the instructions on the App for
the appliance registration and
configuration.
9.3 Configuring the appliance
wireless connection
1. Press the Marche/Arrêt button for a
few seconds to activate the
appliance. Wait about 10 seconds
before proceeding with wireless
configuration.
2. Select a programme by turning the
programme dial.
3. Press and hold the Niveau séchage
and the Mode buttons simultaneously
for a few seconds until a 'click'
sounds. Release the buttons.
appears on the display for 5 seconds
and the indicator starts blinking.
The wireless module begins starting up.
Make sure that you APP is
ready for connection.
4. After about 45 seconds,
(Access Point) appears on the
display.
The access point will be open for about 3
minutes.
5. Configure the My AEG Care app on
your smart device and follow the
instructions to connect the appliance
to your Wi-Fi network.
6. If the connectivity is configured, when
the programme information screen
returns, the indicator is on the
display.
Every time you switch the
appliance on, the appliance
takes 45 seconds to connect
to the network automatically.
When the indicator stops
blinking the connection is
ready.
To switch the wireless connection off,
press and hold the Niveau séchage and
the Mode buttons simultaneously for a
few seconds until the first acoustic
signal. Release the buttons.
appears on the display for 5 seconds.
If you switch the appliance
off and on again, the
wireless connection is
automatically off.
To remove the wireless credentials,
press and hold the Niveau séchage and
the Mode buttons simultaneously for a
few seconds until the second acoustic
signal:
appears on the display for a
few seconds.
9.4 Remote Start
The Remote Start enables you to start a
cycle in remote control.
The Remote Control
activates automatically when
you press the Départ/Pause
button to start the
programme, but it is also
possible to start a washing
programme remotely. This
function is deactivates when
door is open.
When the App is installed and the
wireless connection is complete, you
can activate the Remote Start:
ENGLISH 29
To Next Page
Loading...
