13.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display
comes on.
• The indicator of button Départ/Pause
goes off. The door locked goes
off
• Press the button Marche/Arrêt for
some seconds to deactivate the
appliance.
After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
The indicator appears on
the display to remind you to
clean the air filter (refer to
'Cleaning the air filters' in
'Care and cleaning' chapter).
14. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
14.1 Preparation to drying
1. Press the Marche/Arrêt button for
some seconds to activate the
appliance.
With a drying-only
programme the display does
not show the laundry weight
and the ProSense estimation
is deactivated.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to
dry.
4. Tap on the Mode button twice to
exclude washing and perform drying
only. The SÉCHAGE indicator is on.
The indicators and
appear on the display.
When drying a big amount of
laundry, to have good drying
performances, make sure
that the laundry itself is not
rolled up and that is
uniformly distributed in the
drum.
14.2 Drying - Automatic
levels
1. Tap on the Niveau séchage button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a.
Iron dry: for cotton
items;
b. Cupboard dry: for
cotton and synthetic items;
c. Extra dry: for cotton
items.
The display shows the drying
programme duration.
www.aeg.com38
To Next Page
Loading...
