Problem Possible cause Solution
The buzzer sounds. The
Alarm light flashing.
The temperature in the freezer
is too high.
Refer to "High Temperature
Alarm".
The compressor operates
continually.
The temperature is not set cor-
rectly.
Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
Do not keep the door open lon-
ger than necessary.
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
The room temperature is too
high.
Decrease the room temperature.
The compressor does not
start immediately after
pressing the FROSTMATIC
or COOLMATIC button, or
after changing the tem-
perature.
This is normal, no error has oc-
curred.
The compressor starts after a pe-
riod of time.
Water flows on the rear
plate of the refrigerator.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water
flows into the water collector.
Make sure that products do not
touch the rear plate.
Temperature cannot be
set .
FROSTMATIC or COOLMATIC
functions switched on.
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set
the temperature until the func-
tion has reset automatically. Re-
fer to "FROSTMATIC or COOLMAT-
IC function"..
The temperature in the ap-
pliance is too low/high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at
the same time.
Store less products at the same
time.
The temperature in the re-
frigerator is too high.
There is no cold air circulation
in the appliance.
Make sure that there is cold air
circulation in the appliance.
What to do if…
79
To Next Page
Loading...
