Problem Possible cause Solution
The buzzer sounds.
The Alarm light
flashing.
The temperature in the
freezer is too high.
Refer to "High Tempera-
ture Alarm".
The compressor op-
erates continually.
The temperature is not
set correctly.
Set a higher temperature.
The door is not closed
correctly.
Refer to "Closing the
door".
The door has been
opened too frequently.
Do not keep the door
open longer than necessa-
ry.
The product temperature
is too high.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
The room temperature is
too high.
Decrease the room tem-
perature.
The compressor
does not start imme-
diately after press-
ing the FROSTMAT-
IC or COOLMATIC
button, or after
changing the tem-
perature.
This is normal, no error
has occurred.
The compressor starts af-
ter a period of time.
Water flows on the
rear plate of the re-
frigerator.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
This is correct.
Water flows into the
refrigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector.
Make sure that products
do not touch the rear
plate.
The temperature in
the appliance is too
low/high.
The temperature regula-
tor is not set correctly.
Set a higher/lower temper-
ature.
The door is not closed
correctly.
Refer to "Closing the
door".
The product temperature
is too high.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time.
Store less products at the
same time.
14
www.aeg.com
To Next Page
Loading...
