6.7 Delay Start
Lets to delay the start of a
drying program from
minimum of 30 minutes to
maximum of 20 hours.
1. Set the drying program and options.
2. Touch Delay Start button again
and again.
Time of delay is on the display (e.g.
if the program has to start after 12
hours.)
3. To activate Delay Start option,
touch the Start/Pause button.
Time to start decreases on the display.
6.8 Buzzer
The sound is heard at the:
• cycle end
• start and end of crease guard phase
The buzzer option is by default always
on. You can use this option to activate or
deactivate the sound.
7. STEAM FUNCTION
Steam helps to remove odours like the
outdoor air.
Decreases or removes creases. Makes
the pieces of clothing more flexible.
The pieces of clothing after steam
programme are easy to iron.
At the end of the steam cycles clothes
come out with a residual humidity
appropriate for ironing.
If clothes are not ironed immediately
hang them until they are completely
dry.
At the start, because of wide
types of fabrics, apply small
steam loads. You easily get
the experience, which helps
you to use the sufficient
steam loads.
7.1 How to fill water container
for steam system
CAUTION!
Use only distilled or
demineralized water.
Always when the container
is empty the indicator is
on and you cannot start the
steam programmes.
For the first time you can
use the water attached in the
bottle.
The condensed water is also
applicable for steam system.
The condensate water must
be filtered e.g. with a coffee
filter to remove small pieces
of fluff.
If you dry with standard and
steam programmes, the
water container for steam
system fills automatically.
To fill water container:
1. Turn on the appliance.
2. Set 1 of the programmes with steam
option to check the water level.
3. Pull the water container. Keep it in
horizontal position.
4. Fill the water. until you hear the
acoustic signal.
ENGLISH 13
To Next Page
Loading...
