Problem Possible cause Solution
Many food products are stored at
the same time.
Store less food products at the
same time.
The thickness of the frost is greater
than 4-5 mm.
Defrost the appliance.
The door has been opened often. Open the door only if necessary.
The Frostmatic function is switched
on.
Refer to "Frostmatic function" sec‐
tion.
There is no cold air circulation in the
appliance.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
DEMO appears on the display. The appliance is in the demonstra‐
tion mode.
To exit the demonstration mode,
press and hold the OK button for ap‐
proximately 10 seconds until you
hear a long sound and the display
turns off for a short time.
A or or symbol is shown
instead of numbers on the tempera‐
ture display.
Temperature sensor problem. Contact the nearest Authorized
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
16 ENGLISH
To Next Page
Loading...
