AEG X89264MI10 - Recommendations and Suggestions; Maintenance

3
ENGLISH
1. RECOMMENDATIONS AND
SUGGESTIONS
• The Instructions for Use apply to several ver-
sions of this appliance. Accordingly, you may
nd descriptions of individual features that do
not apply to your specic appliance.
• The manufacturer will not be held liable for any
damages resulting from incorrect or improper
installation.
• The minimum safety distance between the
cooker top and the extractor hood is 650 mm
(some models can be installed at a lower height,
please refer to the paragraphs on working
dimensions and installation).
• Check that the mains voltage corresponds to
that indicated on the rating plate xed to the
inside of the hood.
• For Class I appliances, check that the domestic
power supply guarantees adequate earthing.
• Connect the extractor to the exhaust ue through
a pipe of minimum diameter 120 mm. The route
of the ue must be as short as possible.
• Do not connect the extractor hood to exhaust
ducts carrying combustion fumes (boilers,
replaces, etc.).
• If the extractor is used in conjunction with non-
electrical appliances (e.g. gas burning appli-
ances), a sufcient degree of aeration must be
guaranteed in the room in order to prevent the
backow of exhaust gas. The kitchen must have
an opening communicating directly with the open
air in order to guarantee the entry of clean air.
When the cooker hood is used in conjunction
with appliances supplied with energy other than
electric, the negative pressure in the room must
not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker hood.
• In the event of damage to the power cable, it
must be replaced by the manufacturer or by
the technical service department, in order to
prevent any risks.
• Connect the hood to the mains through a two-
pole switch having a contact gap of at least 3 mm.
• If the instructions for installation for the gas hob
specify a greater distance specied above, this
has to be taken into account. Regulations con-
cerning the discharge of air have to be fullled.
2. USE
• The extractor hood has been designed exclu-
sively for domestic use to eliminate kitchen
smells.
• Never use the hood for purposes other than for
which it has been designed.
• Never leave high naked ames under the hood
when it is in operation.
• Adjust the ame intensity to direct it onto the
bottom of the pan only, making sure that it does
not engulf the sides.
• Deep fat fryers must be continuously monitored
during use: overheated oil can burst into ames.
• Do not ambè under the range hood; risk of re.
• This appliance is not intended for use by per-
sons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• “ CAUTION: Accessible parts may become hot
when used with cooking ap-pliances”.
3. MAINTENANCE
• Switch off or unplug the appliance from the
mains supply before carrying out any mainte-
nance work.
• Clean and/or replace the Filters after the speci-
ed time period (Fire hazard).
- Activated charcoal lter W These lters are
not washable and cannot be regenerated,
and must be replaced approximately every
4 months of operation, or more frequently
with heavy usage.
W
- Grease lters Z The lters must be cleaned
every 2 months of operation, or more fre-
quently for particularly heavy usage, and
can be washed in a dishwasher.
Z
- Control lights, if present.
• Clean the hood using a damp cloth and a neutral
liquid detergent.