6
4. Reassemble Vehicle
a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact
any part of the vehicle.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are
properly tightened.
d. Reconnect negative battery terminal and start engine. Let the vehicle idle for 3 minutes. Perform a final
inspection before driving the vehicle.
5. Service and Maintenance
a. AEM Induction Systems requires cleaning the intake system’s air filter element every 100,000 miles. When
used in dusty or off-road environments, our filters will require cleaning more often. We recommend that you
visually inspect your filter once every 25,000 miles to determine if the screen is still visible. When the screen
is no longer visible some place on the filter element, it is time to clean it. To clean, purchase our Synthetic air
filter cleaner, part number 1-1000 and follow the easy instructions.
b. Use window cleaner to clean your powder coated AEM
®
intake tube.
NOTE: DO NOT USE aluminum polish on powder coated AEM
®
intake tubes.
For technical inquiries
e-mail us at
sales@aemintakes.com
or
call us at
800.992.3000
o. Factory air inducon system.
p. Finished installaon of AEM Intake System.
To Next Page
Loading...