5
e. Place heat shield into factory lower air box. Do not
secure clips unl intake tube is in place.
f. Install included straight hose coupler onto lter adapt-
er and secure with provided hose clamp.
g. Install hump hose coupler onto throle body and se-
cure with provided hose clamp.
h. Install intake tube at throle body rst, then at air
lter. Adjust tube posion in couplers for best t, then
secure by ghtening hose clamps. Secure heat shield
using factory clips at this me.
i. Connect factory EVAP and crank case vent connecons
to ngs on intake tube.
To Next Page
Loading...
