Operation of the device
Place the cleaning pad (2) onto the handle of the device (1) as shown in figure b.
Apply some dentifrice to the brush bristles. Press the power button (10). One of
the indicators starts to light, showing the mode of operation of the device. The
device starts working in this mode. To turn off the device, press the button (10)
again.
Every 30 sec. a vibration signal is triggered, reminding you of the opportunity
to change the operating mode. To change the mode, switch the device off and
on again with the button (10). Then quickly press the button (10) several times
in succession, selecting the desired mode. Each time you press, the mode
changes to the next one. After each use, the toothbrush remembers the last
mode. This mode will be automatically selected the next time the device is
turned on.
Guide the brush head at a 45° angle to the surface of the teeth, as shown in
Figure c. In this position, the toothbrush head works most efficiently.
Device operating modes table
To Next Page
Loading...
