PREVIOUSLY INSPECTION:
E. Front /Rear brake pad wear:
Brake pad wear depends upon the severity of usage, the
type of riding, and road conditions. (Generally, the pads
will wear faster on wet and dirty roads.) Inspect the pads at
each regular maintenance interval.
Check the cutout in each pad.
If either pad is worn to the cutout, replace both pads as a
set. See your dealer for this service.
Front /Rear Fluid Level:
Check the fluid level:
Make the handlebar straight and check the front brake fluid level which should be keep between the
upper and lower limit.
Front/Rear brake fluid refilling method:
1. Keep the handle bar straight and disassemble the 2
screws, take off the cover.
2. Refilling the recommended DOT-4 brake fluid
until the level reaches the upper limit.
3. Put the cover into place and tighten the 2 screws.
To Next Page
Loading...
Need help?
General
