PREVIOUSLY INSPECTION:
K. Front and Rear Shock Absorbers:
Apply pressure on both front handle bar and seat to check the function of front and rear absorbers.
L. Check Front and Rear Light:
Start engine and turn on the R. switch, check the function
of front and rear light.
M. Check Horn:
Turn on the main switch, check the function of horn.
N. Check License Plate:
Check the screw of license plate.
O. Check Muffler:
Check the sound of muffler and the
exhaust leakage or not.
P. Idle Speed
It is not necessary to adjust idle speed. The throttle body is factory pre-set, do not loosen or tighten the
painted bolts and screws of the throttle body. Idle Speed (see page 4).
Loosening or tightening them can cause throttle and idle valve synchronization failure. We recommend
the EFI (electronic fuel injection) system be serviced only by your dealer.
To Next Page
Loading...
Need help?
General
