22
Aermec IDMKUJ. 0113.5356200_01
DMK
EN
22. PROBLEMS AND SOLUTIONS
PROBLEM POSSIBLE CAUSE
WHAT TO DO
power supply
socket
-
Installaon
-
plied
When electrical power is reapplied it is normal for the unit
dehumidify the air as it should
of humidity
reach the desired humidity
The air flow outlet is blocked
Ensure that there are no curtains, furniture or other objects
blocking the intake or outlet of the dehumidifier. See the
section on Minimum clearance space
Cleaning and maintenance
-
Doors and windows are not closed Check that all doors and windows are completely closed
The drier is discharging humid air into the room
discharge humid air outdoors
The room temperature is too low
temperatures. Low ambient temperatures reduce the dehu-
temperatures greater than 5°C
The doors and windows are open
The ambient temperature is less than 5°C This is normal. See the paragraph Automac defrost
The controls cannot be set
-
ous to work for around 3 minutes
This is normal. Wait for around 3 minutes and set the desired
fan speed
The rubber tube for direct discharge may be loose
the paragraph Condensate water collecon
The condensate is to be collected in the bucket
but the rubber tube for direct discharge is also
connected
If condensate is to be collected in the bucket remove the rub-
ber tube for direct discharge and insert the rubber plug in the
outlet tube. See the paragraph Condensate water collecon
The condensate is to be collected in the bucket,
the rubber tube for direct discharge is not installed
but the rubber plug is not correctly inserted in the
outlet tube
Correctly insert the rubber plug into the outlet tube
Installaon
To Next Page
Loading...
