What to do if my AERMEC DMP doesn't start?
If your AERMEC Dehumidifier isn't starting, here are a few things to check: * Make sure the unit is properly connected to an electric power supply. * Ensure the line switch is closed. * Verify that the remote consent is closed. * If none of these work, the circuit board might be faulty and need replacement.
Why does the fan start but the compressor doesn't on my AERMEC Dehumidifier?
If the fan in your AERMEC Dehumidifier starts but the compressor doesn't, it could be due to a few reasons: 1. The compressor circuit breaker might have intervened. If this is the case, wait for the compressor to cool down before trying again. 2. The compressor itself could be faulty and need replacement. 3. A faulty circuit board could also be the cause, requiring replacement.
Essential safety rules for electrical and water products, including user restrictions and operational prohibitions.
Specifies the acceptable room temperature and humidity ranges, and warns against exceeding them.
Covers installer qualifications, refrigerant safety (R134a), and electrical discharge warnings.
Guidelines for selecting a suitable installation location, including integrity checks and storage conditions.
Lists the sequential steps for installing the dehumidifier, from niche creation to grille assembly.
Provides detailed dimensions and instructions for creating a niche for the unit and assembling the cassaforma system.
Emphasizes qualified personnel for electrical work, power supply verification, and proper connection procedures.
Specific details on electric connections, including wiring diagrams and component identification.
Explains the logic behind the dehumidification mode, including humidity set points and compressor/fan activation delays.
Explains error signals, divided into communication errors and alarm signals, with error codes and their meanings.
Lists specific communication error codes (Er:24-Er:30) and troubleshooting steps.
Describes alarm signals (Ex:yy) related to probes and machine settings, including error codes 02 and 12.
Provides a troubleshooting guide with common problems, probable causes, and possible solutions.
Describes signals for anomalies (ERROR) and blocks (RESET), including error codes and user intervention.
Details anomaly signals, error codes, and when to contact the after-sales center.
Explains block signals, error codes, and how to reset the circuit board.
Categorizes error signals into communication errors and alarm signals with their respective codes.
Lists communication error codes (Er:24-Er:30) and troubleshooting steps.
Describes alarm signals (Ex:yy) related to probes and machine settings, including error codes 02 and 12.
General| Brand | AERMEC |
|---|---|
| Model | DMP |
| Category | Dehumidifier |
| Language | English |
To Next Page
