19
CHRONO 19 USER MANUAL
10.1. DESCRIPTION OF THE PANEL
Allows to display and modify
the set points of the relative
humidity requested, they mo-
dify the set speed and all set
point values.
They activate the selection
function of the set speed.
The value 0 indicates the
selection of the automatic
fan function.
Setting the functioning
mode in dehumidification
and heating mode.
MODE: allows to select the
unit functioning MODE, in
automatic.
Unit ON/ OFF.
Confirm
Programming and info
menu (in its sub-menus it is
also used to go back to the
main page))
Enable timed functions
(PARTY and VACANZA)
10.2. COMMISSIONING
The first time the CHRONO 19 is
switched on the display shows the
CLOW signal (the backup capacity is
not sufficiently loaded). To access the
info menu, wait a few minutes. The time
necessary for the backup capacity to
accumulate a minimum load sufficient
for functioning.
10.3. FUNCTIONING MODE
By pressing the MODE
key one of
the following unit functioning modes
can be set:
AUTOMATIC MODE:
1. Selecting AUTOMATIC the
.
symbols are shown on the display.
The unit satisfies the dehumidi-
fication requests depending on
the programmed times. The time
period pathway is indicated by
the flashing
on
the program phase cursor) and
specific if the level is comfort
or economy
. During the time
period when the unit remains in
OFF (standby), the cursor does
not flash and the CHRONO 19
goes into stand by. As well as the
symbol that characterises the au-
tomatic function,
. is added.
MODIFICATION:
During functioning in automatic mode
by acting on the and keys, it is
possible to manually modify the level
set by the program or disable functio-
ning entirely.
This temporary modification is indica-
ted with the flashing
symbol and
lasts until the next time period.
The level selected is indicated by the
respective symbol:
the main window display is the following:
MODO SYMBOLS ON
AUTOMATIC
MODE SYMBOLS ON
COMFORT
To Next Page
Loading...
Need help?
General
