21
FMT10 FLUSH-MOUNTING CONTROL PANEL WITH ELECTRONIC THERMOSTAT
Electronic thermostat for fan coils installed in systems with 4 pipes, 2 pipes and 2 pipes with
heater, with the possibility of connecting two On - Off valves to shut off the water feeding the coils.
Commands simplified with only two selectors for temperature and ventilation control (3 speeds).
External air probe (6m cable supplied with probe-holder) to be positioned inside the fan coil. Flush-
mounting (module 503). For further information, refer to the instructions supplied with the
accessory.
FMT20AW FLUSH-MOUNTING CONTROL PANEL WITH ELECTRONIC THERMOSTAT AND
LCD DISPLAY
Electronic thermostat with LCD display for fan coils installed in systems with 4 pipes, 2 pipes and 2
pipes with heater, with the possibility of connecting two On-Off valves to shut off the water feeding
the coils. Air temperature probe inside the panel. FMT20AW can be combined with SWA external
air and water probes. Flush-mounting (module 503).
PX2 CONTROL PANEL WITH SELECTOR
Control panel with manual command of the ventilation speed, consisting of on/off selector and a 3-
position selector for fan speed. Wall-mounted installation. See the accessory instructions for further
information.
PXA E CONTROL PANEL WITH MULTIFUNCTION ELECTRONIC THERMOSTAT
Multifunction, electronic room thermostat for fan coils in 2-pipe or 4-pipe systems. Simplified
controls with only two selectors to control temperature and ventilation, 3 speeds + automatic
speed, on-off and automatic summer-winter switching, according to water temperature. The
minimum water temperature probe SW is available as an accessory. It interrupts the heating
function when the water temperature is below 35°C. Wall-mounted installation. See the accessory
instructions for further information.
PXA R CONTROL PANEL WITH MULTIFUNCTION ELECTRONIC THERMOSTAT
Multifunction, electronic room thermostat for fan coils in 2-pipe systems and an electric heater.
Simplified commands with only two selectors to control temperature and ventilation, 3 speeds +
automatic speed, on/off, activation of the electric heater when desired, and automatic
summer/winter switchover according to water temperature. Equipped with a minimum water
temperature probe that interrupts the heating function when the water temperature is below 35°C.
By suitably adjusting the dip switches on the card, it can also be used for 2-pipe or 4-pipe systems
without an electric heater. Wall-mounted installation. See the accessory instructions for further
information.
WMT10 CONTROL PANEL WITH THERMOSTAT
Electromechanical thermostat for fan coils installed in 4-pipe, 2-pipe and 2-pipe with heater
systems, with the possibility of connecting two On-Off valves to shut off the water feeding the coils.
The panel is electrically protected by an internal fuse. Continuous or thermostat-controlled
ventilation. Wall-mounted installation.
To Next Page
Loading...
