AERMEC WLRC10 User Manual

11
VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR (IN THE DISPLAY
OF THE INDOOR UNIT)
Through the use of the remote control it is possible to display
the room temperature value read by the indoor unit, or dis-
play the current operating setpoint used by the unit. This infor-
mation is displayed on board the indoor unit’s display.
If the unit is on and if the indoor unit display is enabled, press-
ing the key allows the display of the following values on
the indoor unit’s display (successive pressing passes from one
to the next):
Display of room tem-
perature or operating
setpoint of the
indoor unit
None
visualisation
Set
point
Ambient
air
Outdoor
ari
NOTE:
• The default display on the indoor unit’s display is the
operating setpoint; the room temperature value is
displayed for 3 seconds after which the display re-
turns to the operating setpoint. To display the room
temperature again it is necessary to select the cor-
responding symbol on the remote control.
• On some models there is no external air reading ( ),
in these cases the working set ( ) will be displayed
again.
ACTIVATING / DEACTIVATING THE TURBO FUNCTION
The unit allows the setting of three fan speeds during the vari-
ous operating modes (except the automatic mode and the
dehumidification mode). There is an additional speed called
turbo.
If the unit is on, pressing the button activates or deacti-
vates this function. If the function is active the icon
MODEON/OFF
FAN
CLOCK
X-FAN
TURBO SLEEP LIGHT
TEMP
TIMER OFF
TIMER ON
is shown
on the remote control’s display.
Setting the
TURBO function

AERMEC WLRC10 Specifications

General

Brand	AERMEC
Model	WLRC10
Category	Remote Control
Language	English