10
SETTING OR CANCELLING A PROGRAMMED
SWITCH ON (TIMER ON)
The units possess a timer used to program switching on by
specifying the time that you want the unit to start. If the unit
is switched off (and no other programmed switch on is pre-
sent), by pressing the key you enter the time programming
mode (in this mode the ”ON” icon to the right of the time
flashes) and by pressing the keys and
it is possible to
set the switch on time;
Pressing the button again confirms the time and activates
the timer programme.
If you want to cancel a programmed switch on, just press the
key to cancel the previous programming
Setting the extended
ventilation function
NOTE:
Every time the unit is turned off, the function deactivates
automatically.
NOTE:
Once a programmed switch on is set, the operating mode,
the working setpoint and fan speed, will be the same as
those present when the unit stops.
Setting a programmed
switch on
ACTIVATING / DEACTIVATING THE EXTENDED VENTILATION
During the operation in cooling or dehumidification mode the
condensate caused by the humidity in the air is formed on
the heat exchanger within the unit. This function allows the
ventilation to be extended for two minutes after the unit is
switched off, thereby drying the heat exchanger.
If the unit is on (and the cooling or dehumidification mode is
selected), pressing the
for at least 2 seconds, allows acti-
vating or deactivating of this function. On the remote control
the display the icon
MODEON/OFF
FAN
CLOCK
X-FAN
TURBO SLEEP LIGHT
TEMP
TIMER OFF
TIMER ON
will appear or disappear to indicate if
the function is activated or deactivated.
To Next Page
Loading...
Need help?
General
