9
SETTING A SYSTEM TIME
These units are equipped with an internal clock which can
display the current time; by pressing on the key the clock
icon will start to flash (this flashing will last 5 seconds, after this if
no key is pressed you automatically exit the time modification
mode); while the clock icon is flashing it is possible to change
the system time using the keys and
to increase or de-
crease the displayed time; once the desired value is set you
need to wait 5 seconds or press the key again to confirm
the value (once confirmed the clock icon will stop flashing)
SETTING OR CANCELLING A
PROGRAMMED SWITCH OFF (TIMER OFF)
The units possess a timer used to program switching off by
specifying the time that you want the unit to deactivate. If
the unit is switched off (and no other programmed switch off
times are present), by pressing the key you enter the time
programming mode (in this mode the ”OFF” icon to the right
of the time flashes) and by pressing the keys and
it is
possible to set the switch off time;
Pressing the button again confirms the time and activates
the timer programme. If you want to cancel a programmed
switch off, just press the key to cancel the previous pro-
gramming
Setting the
system time
Setting a
programmed
deactivation
ATTENTION:
The units can simultaneously manage an ignition timer
and one-off, so as to provide a time slot within which allow
operation of the unit
To Next Page
Loading...
Need help?
General
