Aeroball Sr.2 - Disassembly Instruction

To Previous Page

Aeroball Senior 2 Manual

INSTRUCTIONS FOR DISASSEMBLY

 Detach the Velcro that bound the housings to the roof. Remove and put away the roof

(reverse step 21).

 Detach each housing from the center court separator. Detach left housing from the right

housing by undoing the straps at the top (reverse steps 19 through 17).

 Detach and put away all 24 yellow spring wraps (reverse step 20).

 Unclip the housing from the loops, starting with the bottom springs (reverse steps 16

and 15). Put away both housings and the large springs.

 Using a ladder, remove the upper horizontal structure. Start with the 7 horizontal

support pieces at the top (reverse step 11).

 Repeat for the middle horizontal structure (reverse step 10 and 9). Remove the padded

court separator from the center support (reverse step 8).

 Remove and put away the top vertical risers, corners and centers (reverse steps 7 and

6).

 Detach and put away all the padded spring covers that surround the trampoline mats

(reverse steps 14).

 Unclip and put away all small springs (reverse steps 13 and 12). Then fold and put away

each trampoline mat.

 Remove the lower vertical risers from their base plates (reverse step 5) and put away.

 Remove all base supports underneath the structure (reverse steps 4 through 2). Then

detach the pieces remaining (reverse 1) and put away.

 Check to make sure all the parts have been put away properly and that the kit is

complete.