Aeroe Spider Rear Rack User Manual

Thanks for choosing
We hope that this is the start of a long and happy relationship that will enable you to use your bike
more often, for more adventures in an easier and more enjoyable way.
If you’re like us and tend to skip the instructions and just start putting it together. . . . . . we understand.
However if you would like some help getting set up, below are some important and handy tips and
tricks for installing your aeroe gear.
All you need to install any of our products is a standard 5mm allen key. Take a moment to familiarise
yourself with some of the jargon below shown on the spider rear rack. The following steps will then
allow you to get setup quickly and easily so you can get out and start enjoying your new gear!
Tool required for install - ‘5mm allen key’
spider rear rack ‘feet’ and ‘straps’ to
connect to seat stays
spider rear rack ‘cradle’ which can
be located on top or sides of rack
(or both). Cradle come with in built
‘cradle straps’ for easy use.
‘spider rear rack’
We love seeing and hearing about your adven-
tures around the world. . . . . . if you want to reach
out or still need installation help - we would love
to hear from you! You can reach us at
team@aeroe.com or on facebook and instagram
#aeroebikepack or check out aeroe.com for
more information.
Thanks again from the aeroe team!

Aeroe Spider Rear Rack Specifications

General

Brand	Aeroe
Model	Spider Rear Rack
Category	Bicycle Accessories
Language	English

Summary

Welcome to Aeroe

Key Components and Tools

Identifies essential parts like spider rear rack, cradles, straps, and the required 5mm allen key.

Installing the Aeroe Spider Rear Rack

Step 1: Loosen Straps

Unscrew bolts on straps using a 5mm allen key for initial positioning on seat stays.

Step 2: Position and Initial Tightening

Position rack evenly, tighten straps to 75% on one side, then the other, ensuring stability.

Step 3: Adjust Rack Height and Feet

Loosen bolts to slide rack down or rotate feet for optimal fit on seat stays.

Step 4: Finalize Rack Installation

Tighten all rack straps to 100% (approx. 4Nm) and ensure it is securely installed.

Installing the Aeroe Cradle

Step 5: Attach Cradle to Rack

Unscrew cradle screws, attach cradle parts to the spider rear rack tube, and screw back together.

Step 6: Secure Cradle and Load Gear

Firmly tighten cradle, check stability, and use cradle straps for securing gear.