cause an unsafe condition.
7) Do not install pump where it will be exposed to weather, do not store pump in
temperatures below freezing.
8) Ensure pump is securely mounted prior to operation.
9) Read and observe all important markings on pump.
10) Ensure that extension cords (if required) have the correct or higher rating
(amperes or watts). Ensure cord is properly positioned to avoid tripping.
11) To avoid injury, do not contact moving parts or hot parts such as heaters, refl ec-
tors, lamp bulbs, and the like.
12) Always unplug an appliance from an outlet when not in use, before putting on
or taking off parts, and before cleaning.
Disconnect electrical power at the circuit breaker or fuse box before installing this
product. Install this product where it will not come into contact with water or other
liquids. Install this product where it will be protected. Ensure product is Earthed. Fail-
ure to follow these instructions can result in death, fi re or electrical shock.
Correct Installation is your responsibility.
Make sure you have the proper installation conditions and that installation clear-
ances do not block airfl ow.
This product must be installed on a fl at, horizontal surface.
Mounting the product to a stable, rigid operating surface and using shock mounts
will reduce noise and vibration.
Remove plug from the OUT port. Connect with pipe and fi ttings that are the same
size or larger the than product port.
Install relief valve and gauge at outlet to monitor performance. A check valve may
be required to prevent back streaming through the compressor.
It is your responsibility to contact a qualifi ed electrician and ensure that the electri-
cal installation is adequate and in accordance with all the national and local codes
To Next Page
Loading...