Use only recommended air handling parts acceptable for pressure not less than 10
psi. When provided, motor terminal covers must be in place for safe operation. Prod-
uct surfaces may become hot during operation. Do Not direct air stream at body.
Air stream from product may contain solid or liquid material that can result in eye or
skin damage, wear proper eye protection. Do Not spray fl ammable or combustible
liquid. Failure to follow these instructions can result in burns, eye injury or other seri-
It is your responsibility to operate this product at recommended pressure duty and
room ambient temperature.
If pump fails to start or slows down signifi cantly under load, shut off and disconnect
from power supply. Check that the voltage is correct for the pump
Disconnect electrical power supply cord before performing maintenance on this
product. If product is hard wired into system, disconnect electrical power at the cir-
cuit breaker or fuse box before performing maintenance on this product. Failure to
follow these instructions can result in death, fi re or electrical shock. Product surfaces
may become hot during operation, allow product surfaces to cool before handling.
Do Not direct air stream at body. Air stream from product may contain solid or liquid
material that can result in eye or skin damage., wear proper eye protection. Clean
this product in a well ventilated area. Failure to follow these instructions can result in
burns, eye injury or other serious injury.
It is your responsibility to:
Replace diaphragms every twelve (12) months or less.
When air pump is switched off, apply pest repellent surface spray
There must be adequate ventilation for the air pump at all times.
Regularly inspect and make necessary repairs to product in order to maintain
Make sure that pressure is released from product before starting maintenance.
Never add oil to this oil-less compressor.
Check intake fi lter after fi rst 500 hours of operation. Clean fi lter and determine how
frequently fi lter should be checked during future operation. This one procedure will
help to ensure the product’s performance and service life.
Do not use kerosene or ANY other combustible solvent to clean product.
1. Remove fi lter and clean using detergent and water
2. Rinse fi lter well and air dry.
To Next Page
Loading...