A1C-SRT-4/PT Cruiser Supported Parameters (PID’S)
1. INTAKE AIR- Intake Air Temperature taken at the throttle body inlet
2. AMBIENT AIR TEMPERATURE – air temperature at the air filter
3. COOLANT TEMP- Engine Coolant Temperature
4. RPM- engine Revolutions Per Minute
5. CALCULATED AIR FLOW RATE- Mass Air Flow (lbs/min) calculated by the
PCM
6. BAROMETRIC PRESSURE – ambient (outside) air pressure
7. MANIFOLD PSI- Manifold Air Pressure (psi)
8. THROTTLE POS PCT- Throttle Position percentage (0-100%)
9. THROTTLE VOLTS- Throttle Position sensor output (0-5 volts)
10. MILES PER HOUR- Miles Per Hour
11. KNOCK RETARD- Knock Retard (degrees)
12. KNOCK SENSOR RAW VOLTAGE – voltage output of knock sensor
13. WASTEGATE SOLENOID % DUTY CYCLE – programmed wastegate
Duty cycle, 0-100%
14. SHORT TRIM FUEL TRIM- short term fuel trim
15. LONG TRIM FUEL TRIM – long term fuel trim
16. OXYGEN SENSOR - O2 bank 1 sensor in millivolts
17. FUEL LEVEL – amount of fuel in the tank in gallons.
18. CALCULATED EXHAUST GAS TEMP – calculated by the PCM
19. TRANS TEMP- Transmission Temperature (auto transmission only)
20. RUN TIME MINS- engine run time since last engine start. Can be used as a trip
timer.
21. BATTERY VOLTAGE- Alternator/battery output voltage
22. PULSE WIDTH- injector pulse width
23. FUEL TEMPERATURE
24. BASE SPARK TIMING – timing level commanded by the PCM before
adjustments due to temperature, knock, etc.
25. SPARK ADJUST – adjustments made to base spark timing
26. IGNITION ADVANCE- final ignition timing advance after adjustments
27. ENGINE LOAD-calculated Engine Load (0-100%)
28. THROTTLE INLET PRESSURE (TIP SENSOR) - pressure at throttle inlet
29. Miles Per Gallon- instantaneous fuel economy
30. Calculated net horsepower
31. TOTAL MISFIRES- Total misfires of all cylinders.
32. Analog 1 – analog input #1.
32. Analog 2 – analog input #2
BOLD parameters are found on the Interceptor Pro version only.
To Next Page
Loading...