Aeropro A220 - 0.1 Introduction; 0.2 Certification Basis; 0.3 Manufacturer; 0.4 Warnings, Cautions, and Notes

Aeropro CZ - A220 taildragger - Pilot Operating Handbook and Flight Training Supplement
March 21, 2020
7
0. General information
0.1 Introduction
This handbook is provided with your aircraft to allow you to attain as much knowledge about the aircraft
and its operation as possible. This manual is following ASTM F2746-14 Standard Specification for Pilot’s
Operating Handbook (POH) for Light Sport Airplane. Read this manual thoroughly before your first flight
and make sure you understand all the information contained within. This aircraft is equipped with a non-
certified engine that meets the ASTM F2339-17 engine standard. Flying this aircraft must always be done
with the possibility of a safe landing due to loss of engine power.
Pay attention to the fact that you as the pilot are fully responsible for the safety of your passengers and
persons or property on the ground.
0.2 Certification basis
This aircraft was manufactured in accordance with Light Sport Aircraft airworthiness standards and does
not conform to standard category airworthiness requirements.
0.3 Manufacturer
Aeropro CZ
Mladá 835
687 25 Hluk
Czech Republic
0.4 Warnings, cautions and notes:
In this handbook the following is used to highlight especially important information:
WARNING
Information which could prevent personnel injury or loss of life
CAUTION
Information which could prevent damage to equipment
NOTE
Information of special importance to pilots