FL20X Installation Compliance
Document # S200-FL20X-007
Rev 1.3 12/22/2014
Page 1 of 1
Aerospace Logic Inc.
Tel. 416-628-0725
www.aerospacelogic.com
1. Installation Procedures and Limitations
Should your specific aircraft not be listed on our STC Approved Model List
(AML), contact your local FSDO or flight authority for installation requirements
BEFORE commencing any installation tasks.
Installation must be in accordance with the following FL20X published
documents:
a. Installation Instructions,
b. Wiring and Installation Schematic, and
c. Instrument Setup.
2. Installation Location and Visibility
The products are to be installed in existing panel holes and will replace existing
instrumentation. As primary replacement products it is recommended and
preferred that they be placed in the same panel location as the original
equipment. Their visibility and placement relative to other instruments are the
same or similar to the existing instruments. Where they are installed in a different
location it is the responsibility of the installer to ensure that they are visible to the
pilot under all conditions.
3. TSO COMPLIANCE NOTICE
The conditions and tests required for TSO approval of this instrument are
minimum performance standards. Those installing this instrument on or in a
specific type or class of aircraft, must determine that the aircraft installation
conditions are within the TSO standards. TSO articles must have separate
approval for installation in an aircraft. The instrument may be installed only
according to 14 CFR part 43 or the applicable airworthiness requirement.
To Previous Page
Loading...
Need help?
General
