What to do if AEROTECNICA COLTRI MCH-22 overheats?
If your AEROTECNICA COLTRI Air Compressor is overheating, verify the direction of rotation. If the rotation is incorrect, correct it. For other potential issues, like dirty cooling tubes or incomplete valve closure, it is recommended to contact technical assistance.
Why does my AEROTECNICA COLTRI MCH-22 Air Compressor air smells of oil?
If the air from your AEROTECNICA COLTRI Air Compressor smells of oil, it could be due to a exhausted cartridge filter. Replace the filter. It could also be caused by worn piston rings, in which case you should contact technical assistance.
What to do if the flow rate diminishes without rpm decreasing in my AEROTECNICA COLTRI MCH-22?
If the flow rate of your AEROTECNICA COLTRI Air Compressor diminishes without a decrease in RPM, check the following: * Loose fittings or leaking seals: Use soapy water to check for leaks and eliminate them. * Clogged intake filter: Replace the filter. * Kinked intake extension: Straighten the extension or use a stiffer pipe. For issues related to valves, a worn 4th stage piston, or worn piston/piston rings, contact technical assistance.
Why AEROTECNICA COLTRI MCH-22 Air Compressor rotation speed and flow rate decrease?
If the rotation speed and flow rate of your AEROTECNICA COLTRI Air Compressor are decreasing, it could be due to the following reasons: * Motor power too low: Check the motor and the line. * The belt slips: Restore proper belt tension.
How to fix AEROTECNICA COLTRI MCH-22 Air Compressor when the electric motor does not start?
If the electric motor of your AEROTECNICA COLTRI Air Compressor does not start, the cause might be a missing phase. Check the fuses or condenser.
General| Model | MCH-22 |
|---|---|
| Category | Air Compressor |
| Brand | Aerotecnica Coltri |
| Power Source | Electric |
| Cooling System | Air Cooled |
| Lubrication | Oil |
| Air Quality | DIN EN 12021 |
| Max Pressure | 330 Bar (4786 PSI) |
To Next Page
