o
When the cuff
IS
positioned correctly,
close the fabric fastener FIRMLY
Notes:
o
Make certain the cuff fits snugly around yo
o
The cuff should make good contact with your skin. You should
be able to fit your index finger between the cuff and your arm
easily, so you can pull the cuff off and on.
o
Make sure that there are no kinks in the air tubing.
Taking measurements on the right arm
Please note the following points when
applying the cuff to your right arm. Apply the
cuff so that the air tube is at the side of your
elbow.
Notes:
o
Be careful not to rest your arm on the air
tube, or otherwise restrict the flow of air to
the cuff.
o
Apply the arm cuff so that no part of the
cuff is positioned over the elbow joint. The
cuff should be 1 to 2 cm above the elbow.
o
If used 2 times per day, the cuff will last for 3 years.
o
The blood pressure can differ between the right arm and the left arm,
and therefore also the measured blood pressure values can be
different. Aesfee recommends to always use the same arm for
measurement. If the values between the two arms differ substantially,
please check with your physician which arm to use for your
measurement.
1. Measurement of Blood Pressure
1.1 Automatic Test
Pressthe Switch button, the arm cuff will start to inflate, do not move or
lalk during measurement.(lf mmHg appears on the screen, the measurement
unit is mmHg, or kPa.)
(!)14lT3 (914113 @(914113
I.)
P
II.
I.)
120
11
Q
-+
110
-+
80
~"
~"
I~,
70
•
Early display
Automatically
charging
When oir is slowly
exbcvsted.vctoe on
the display screen
drops/meanwhile
heartbeat diagram
(heart shape) is
flickering
After finishing
measuring/the
blood pressure
monitor
automatically
exhausts air and
displays blood
pressure value
and pulse rate.
1.2 View and Delete Memory
The unit is designed to store the blood pressure and the pulse rate in
Ihe memory for two people (user 1 and user 2) every time a measurement
is completed.
The unit automatically stores up to 99 sets of measurement values (blood
pressure and pulse rate) for each user (1 and 2).
When 99 sets of measurement values are stored, the oldest record is deleted
10
save the most recent values.
• View the records
Pressthe "8" button to display the most recent set of individual measurement
values on the screen. The values are displayed from the most recent to the
oldest. the first display is average value of the last three times of
measurement.
Pressthe "8" button again the result from the most recent measurement is
displayed. Pressthe "8" button repeatedly to cycle through the previous
measurement results.
average value measured value measured value measured value
-+ .
for the 3 times for the
i
st time for the 2nd time for the 3d time
To Next Page
Loading...