Aetertek AT-216 - Quick Start Guide

Quick Start
R
Super Remote Dog Trainer
1
Step 1 Install the antenna onto the transmitter. Make sure the
antenna is securely attached.
4
Step 4 Charge the receivers.
A RED LED light of the receiver is on during charging. When
charging is over, the red LED light will be off with the
BLUE LED light on. Full battery charge takes about 3 hours.
Tips: Recommend to charge the receiver upto 4 hours
for the first 3 times .
2
Step 2 Install the 9V battery into the transmitter correctly .
(Note: pay attention to the positive and negative poles )
a:Press and hold
on On/Off
button until the
red LED light to
be solid.
Note:if receiver just
charg ed, the red LED
light is solid and receiver
is waiting for sync, so no
need to do this
Step 5: Sync the receiver and transmitter.
b:press down Shock,
Beep or Vibrate button,
receiver will get to be
communicated
with transmitter.
5
3
Step 3: Screw the metal prongs onto the receiver till securely attached.
a: Unplug the charger, the red Led light is solid and receiver
is waiting for sync ;
Note:if receiver had been turned off and still have power
remained,press and hold on the On/Off button until the red Led
light to be solid, then the receiver is waiting for sync. b :push
any of the function buttons
(shock, beep, vibrate) on the transmitter. As soon as the
receiver pairs with the transmitter, the RED LED light turns
off and BLUE LED light flashes every 10 seconds.
-03-