Page 12
5
Step 17: Reconnect the vent fitting. It will snap over without having to release the plastic clip. Pull up
slightly to confirm installation.
Step 18: Installation is complete. Any codes can be cleared with a code reader or by disconnecting the
battery. You will lose any radio presets with battery disconnection.
NOTE: If removal of the vent insert is required, it can be pulled out with internal snap ring pliers.
Refer to Figure I for Steps 17-18. ( For V6-3.5L (tt) only, not necessary on V6-2.7L (tt) )
Figure I
INSTALL
To Next Page
Loading...
