aFe Power Magnum FORCE

Need help?

Do you have a question about the aFe Power Magnum FORCE and is the answer not in the manual?

Summary

REMOVAL

Figure A: Steps 1-4

Disconnect MAP sensor, loosen OE intake clamps, unclamp airbox, and remove OE intake.

Figure B: Step 5

Carefully remove plastic wire harness clips from the back edge of the lower airbox.

INSTALLATION

Figure C: Steps 6-7

Install aFe housing, fasten clips, insert filters, and place clamps loosely.

Figure D: Steps 8-9

Remove MAP sensor from OE intake and install it on the aFe intake tube using the provided grommet.

Figure E: Steps 10-14

Install couplings, fit tubes, tighten clamps, connect sensor harness, and install trim.

Vent Insert Installation

Figure F: Step 15

Locate the OE plastic tube feeding the driver's side turbo inlet for vent installation.

Figure G: Step 16

Locate the valve cover vent tube feeding into the driver's side turbo inlet.

Figure H: Step 17

Release clip and pull vent fitting off the turbo inlet tube, noting sensor and wire harness.

Figure I: Step 18

Insert vent fitting with slash cut facing turbo inlet, ensuring a snug, direction-dependent fit.

Figure J: Steps 19-20

Reconnect vent fitting, confirm installation, and follow final steps for codes and CARB sticker.

Warranty Information

General Terms

Details warranty coverage, limitations, and process for claims.

Warranty Duration by Product Category

Lists warranty periods for different aFe product types.