AFLOWT UF Series - APPENDIX B. Report on Mounting and Start-Up Procedure

15
APPENDIX B. Report on mounting and start-up procedure
(recommended)
REPORT
on mounting and start-up procedure
for AFLOWT UF flowmeter, serial No. ________(sheet __ of ____)
UF-5__ d design version, channel No. _____
Beam 1 – PEA1.1 No. ______ / PEA1.2 No. _______ ;
Beam 2 – PEA2.1 No. ______ / PEA2.2 No. _______ ;
Beam 3 – PEA3.1 No. ______ / PEA3.2 No. _______ ;
Beam 4 – PEA4.1 No. ______ / PEA4.2 No. _______ ;
1. Site
______________________________________________________________
organization name, postal address, tel/fax
_________________________________________________________________
2. Site characteristics: DN of measuring cut _______ mm;
PEA installation diagram ____________ ; negative flow ________
Type of sounding _________, beam
Table B.1
Type of hydraulic
resistance
Length
of a straight run, m
To PEA1.1, 2.1, 3.1, 4.1
After PEA1.2, 2.2, 3.2, 4.2
3. Parameters of the medium.
3.1. Kind of liquid _____________________________________________
3.2. Temperature of liquid: maximum _________ C
minimum _________ C
average 0.5 (t
max
+ t
min
) = _________ C
3.3. Kinematic viscosity ratio of liquid,  = _________ m
2
/s
4. Length of CS-PEA communications cables
Table B.2
Parameter
Parameter value in the channel with PEAs
PEA1.1-
PEA1.2
PEA2.1-
PEA2.2
PEA3.1-
PEA3.2
PEA4.1-
PEA4.2
Length of CS-PEA communications ca-
bles, m