AGA marvel 6CRF - Adjusting the Temperature Control; Defrosting Instructions

ADJUSTING THE TEMPERATURE CONTROL
C
O
L
D
E
R
Adjusng the temperature control
Aer plugging in the units power cord set the temperature con-
trol midway between the numbers. Aer 2 hours adjust to the
temperature that suits you. The higher the number you select,
the cooler the temperature. (See Figure 7).
The temperature control knob is located at the boom, front of
the cabinet, just behind the square opening near the middle of
the grille.
Figure 7
Defrosng Instrucons
Never use a scraper or any tool that might scratch or pierce the
cooling plate. Follow these steps whenever 1/4 inch or more of
frost accumulates.
1. Disconnect the power cord and set the temperature control
knob to the “OFF” posion.
2. Remove the contents from the unit.
3. Place pans of hot water on the cooling plate if you wish to
speed up defrosng.
4. Wipe out the interior and replace the contents.
5. Connect the power cord to the outlet.
6. Set the temperature control to the desired level.
In the Event of a Power Failure
Minimize the number of door openings to prevent a gradual rise
in temperature while the power is o.
NOTE: If a power interrupon occurs, the unit may take ve (5) to
ten (10) minutes to restart.
10