EasyManua.ls Logo

AGCO Power 33 - User Manual

AGCO Power 33
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Workshop Service Manual
4th Generation Engines
AGCO POWER
Linnavuori
AGCO Power - Linnavuorentie 8-10 - FIN-37240
Linnavuori, Nokia, Finland
© AGCO 2014
November 2014
8370 79492
EAME
English

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the AGCO Power 33 and is the answer not in the manual?

Summary

Introduction to AGCO POWER 4 th Generation Engines

Engine Service and Operation Safety Precautions

Critical safety guidelines and remarks for engine service and operation.

Guidance for Engine Users

Information for users regarding engine identification, operation, and maintenance.

AGCO POWER 4 th Generation Engine Construction Overview

Detailed explanation of the engine's mechanical components and systems.

AGCO POWER 4 th Generation Engine Specifications

Engine Technical Data and Component Specifications

Detailed technical specifications for engine components like cylinder block, head, crankshaft, etc.

Component Tightening Torques

Specific torque values for various engine fasteners and components to ensure correct assembly.

Special Tools for Engine Maintenance

List and descriptions of specialized tools required for engine maintenance and repair procedures.

Liquid Quality Requirements for Engine Fluids

Guidelines for the quality and specifications of lubricating oil, coolant, and fuel.

Terminal Diagram (3-6 Cylinder Engines)

Electrical terminal diagram for 3-6 cylinder engine configurations.

Terminal Diagram (7 Cylinder Engines)

Electrical terminal diagram for 7 cylinder engine configurations.

Maintenance Procedures for AGCO POWER Engines

Cylinder Block Maintenance Procedures

Procedures for measuring wear, removing, checking, and changing cylinder block components.

Flywheel Housing Maintenance

Procedures for fitting the flywheel housing and changing the crankshaft rear oil seal.

Cylinder Head Maintenance and Inspection

Steps for removing, checking, and fitting the cylinder head and its components.

Valve Mechanism Reconditioning and Adjustment

Procedures for reconditioning the valve mechanism and adjusting valve clearances.

Crankshaft Removal, Checking, and Fitting

Detailed steps for removing, checking, changing gears, and fitting the crankshaft.

Connecting Rods and Pistons Maintenance

Procedures for removing, changing bearings, checking, and fitting connecting rods and pistons.

Counterbalance Unit Maintenance (4 Cylinder Engines)

Procedures for removing, reconditioning, and fitting the counterbalance unit.

Flywheel Maintenance Procedures

Instructions for changing the starter ring gear and fitting the flywheel.

Timing Gear Assembly Procedures

Steps for removing and fitting the timing gear casing, hub, and related components.

Lubrication System Maintenance

Procedures for oil pressure regulating valve, oil pump, and piston cooling nozzles.

Cooling System Maintenance

Instructions for removing, testing, replacing thermostats, and reconditioning coolant pumps.

Air Intake System Checks

Procedures for checking the air cleaner, inlet/exhaust pipes, and turbocharger.

Fuel System Maintenance Procedures

Steps for bleeding the fuel system, measuring feed pressure, and inspecting injectors.

SCR System Maintenance and Components

Maintenance of the SCR system, including dosing module and supply module installation.

Engine Control System Maintenance

Procedures for changing the ECU, wiring sets, and engine control system sensors.

AGCO Power 33 Specifications

General IconGeneral
BrandAGCO Power
Model33
CategoryEngine
LanguageEnglish

Related product manuals