To Next PageTo Next Page
Need help?Do you have a question about the AGCO FENDT 1046 Vario S4 and is the answer not in the manual?
General| Engine Type | Diesel |
|---|---|
| Engine capacity | 12.4 l |
| Maximum Speed | 60 km/h |
| Transmission | Vario |
| Rear tyres | 710/70 R38 |
| Hydraulic Pump Flow | 110 L/min |
| Tire Size (Rear) | 710/70 R38 |
| Engine | MAN |
Provides essential safety advice, information on toxic substances, and environmental protection measures.
Explains safety signs, designations (DANGER, WARNING, CAUTION), and important terms for safe operation.
Outlines critical safety guidelines and procedures to follow before, during, and after maintenance work.
Covers general safety warnings, cleaning procedures, and essential pre-maintenance checks for safe operation.
Details procedures for checking, draining, and replacing engine oil and oil filter for optimal engine performance.
Explains how to change fuel filters, drain water/dirt, and bleed air from the fuel system.
Covers cleaning the cooling system, checking coolant levels, and refilling with coolant to prevent overheating.
Provides instructions for changing front axle differential oil and bleeding the hydrostatic fan drive suction line.
Details procedures for checking transmission oil levels, draining, filling, and changing filters.
Covers checking hydraulic oil levels, draining, filling, and changing hydraulic system filters.
Explains how to check steering for leaks and damage, and adjust wheel toe-in.
Describes procedures for changing fresh air and recirculation filters for cabin air quality.
Outlines how to test the compressed air system and replace the air dryer cartridge.
Covers battery maintenance, electric welding precautions, and lighting adjustments.
Provides fuse assignment details for identifying and replacing blown fuses in the electrical system.
Explains how warning and fault messages are displayed and how to interpret them for troubleshooting.
Lists fault codes, their causes, consequences, and recommended remedies for diagnosing issues.
Details procedures for operating the tractor in emergency modes, including transmission and control unit faults.
Provides general specifications including dimensions, weights, and tire information for tractor models.
Covers tire pressures, wheel changes, combinations, and track widths for optimal vehicle performance.
Details operating fluid specifications, filling quantities, change intervals, and notes on biodiesel and AdBlue®.
Information regarding the process for registering the vehicle on the AGCO Net system for service and warranty.
Illustrates lubrication points for tractor components, specifying intervals and greasing types for longevity.
Outlines recommended maintenance tasks and intervals based on operating hours and time.
