To Next Page
A
Angela HenryAug 4, 2025
What to do if AGCO Farm Equipment moisture readings are high or low?
- CcrystaldavidsonAug 4, 2025
If you're getting moisture reading errors (either high or low) on your AGCO Farm Equipment, there are several potential causes: * A disconnected or bad connection between the star wheels and DCP. Reconnect the wire to solve this. * Low power supply to the DCP. Ensure a minimum of 12V by checking the voltage at the box. * Ground contact with one or both star wheels and the baler-mounted processor. Reconnect to fix this. * A short in the wire between the star wheels and DCP. Replacing the wire should resolve this. If none of these steps improve the situation, further assistance may be needed.
General
