EasyManuals Logo

AGCO VALTRA A114 HiTech User Manual

AGCO VALTRA A114 HiTech
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
WARNING: Rollover risk.
Do not disengage the clutch or attempt to shift gear after you have started downhill.
When driving down a slope, use the engine brake to slow the tractor down. Choose the same gear ratio
as used when climbing a slope.
Engage four-wheel drive (if fitted) to enable four-wheel braking.
Do not work near the edge of ditches and
banks, as they may collapse. The tractor must
always be kept a distance from the edge that is
equal to or greater than the height of the bank
or ditch.
GUID-C46FB350-EA42-48A2-8484-16B5FF90DE4F-high.jpg [High]
Fig. 13
Preferably, climb or descend a slope in a straight line, but do not cross it. When this is not possible, adhere
to the following precautions:
Avoid holes and dips when driving downhill.
Avoid stumps, stones and raised areas when driving uphill.
When turning, avoid turning towards the top of the slope. Always slow down and take a wide turn.
Keep the heavier end of the tractor facing towards the top of the slope when driving up and down it.
When driving across a slope with a tractor fitted with implements on one side, these implements must:
Always face towards the top of the slope;
Never be raised; and
Be left as close as possible to the ground.
When towing a load at transport speed, lock the drawbar in the centre position and use a safety chain.
Do not use the tractor to round up livestock.
Preventing a rear overturn
WARNING: Rollover risk.
Hitching a load to the rear axle or on any other part located above the rear axle may
cause a rear overturn.
Do not pull anything using the top link connection or from any point above the centre line of the rear
axle. Always use aValtra-approved drawbar and only use a lockable drawbar pin.
When using a drawbar for a three point hitch, use the stabilisers and keep the drawbar in the bottom
position.
Use front weights to increase tractor stability when towing heavy loads or to counterbalance the weight
of a heavy rear-mounted implement.
Start o slowly and then gradually increase speed.
Do not release the clutch suddenly.
If a heavy load or immovable object is attached to the tractor, incorrect use of the clutch may cause the
tractor to overturn.
If the front end of the tractor starts to lift, disengage the clutch.
2. Safety instructions and safety items - Warranty
39
ACW2184250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AGCO VALTRA A114 HiTech and is the answer not in the manual?

AGCO VALTRA A114 HiTech Specifications

General IconGeneral
BrandAGCO
ModelVALTRA A114 HiTech
CategoryTractor
LanguageEnglish

Related product manuals