16 17
ageLOC Body Shaping Gel
Setting Conductor
Use this application three times each week to visibly contour,
firm, and smooth skin on arms, thights, abdomen, and
buttocks.
GS
Preparation: Attach the Body Conductor
to the device
Figure 1).
step 1: Use on clean skin. Apply an ample
amount of ageLOC Body Shaping Gel to
the desired area.
step 2: Push the selection button until the
number 4 is lit on the display
Figure 2). This
application will take 5 minutes per area.
Pro Tip: 5 minutes is the recommended
application time for one area, but you may
not need the full 5 minutes.
step 3: Thoroughly wet hands with NaPCA
Moisture Mist or water. Hold the device with
a moistened hand while touching the chrome
plate on the back and begin to slowly glide the
conductor head over your skin
Figure 3).
The device will beep once, twice, or three
times to indicate that it has automatically
adjusted to your skin. After this, your galvanic
application has begun, and the device will
beep every 10 seconds to indicate the unit is on and working,
and every 5 seconds when your application is almost
complete.
step 4: When your galvanic
application is over, the device will
emit a long beep followed by two
short beeps and automatically turn
o. Repeat steps 1 through 3 for
each targeted area. When all
applications are done, remove any
remaining product from your skin
and the device with a damp towel
Figure 4).
Apply ageLOC Dermatic Eects
®
twice daily to help your
skin stay visibly smooth and contoured. On days when you use
ageLOC Body Shaping Gel, apply ageLOC Dermatic
Eects after your galvanic application.
Figure 2
Figure 4
Figure 3
EN EN
Figure 1
To Next Page
Loading...
