7
How to Install II
How to Install II
3. After relocating to desire place, should make a machine balance by using high & low controlling
bolts and level checker.
The position of level checker should be based on box beam, connecting bar and side panel (left, right).
4. ANAPURNA MV is a device that needs compressed air.
Air line connected to Air-compressor or installation place should be mounted on right side of
equipment.
-The diameter of Air Inlet Tube is Φ6.
-The pressure of Compressor is 4~8kgf /㎠, Capacity of above 2HP.
(640 kcal/hr,760W) Air production is over 6 LPM.
★ The Compressor must be Oil-less product.
★ It is recommended that the compressor should be run independently.
5. Besides the standard power grounding, the print in good quality can be obtained
by connecting grounding line to controller panel in the middle of Machine rear side.
To Next Page
