9
How to Install IV
How to Install IV
-
-
1 (HEAD CLEANING & INK SYPPLY)
1 (HEAD CLEANING & INK SYPPLY)
STEP 1. After removing the cap of ink tube in refill connecting part, push
the solution which remains in ink tube into sub ink tank by using tubing pump
including filter.
.
Be careful that a solution should not be smeared on the
printer while carrying out solution or ink handing work.
If smeared on the printer, its surface will be discolored.
STEP 2. Connect ink supplying tube in refill system with tube connector
of printer.
Make sure that the ink tube and connector of printer are
tightly connected by the NUT in end of supplying tube.
Impact can cause of tubing-out problem.
Warning
Warning
To Next Page
