Additional Safety Notices
The following general safety precautions
must be observed during all phases of
operation of this instrument. Failure to
comply with these precautions or with
specific warnings or instructions else-
where in this manual violates safety stan-
dards of design, manufacture, and
intended use of the instrument. Agilent
Technologies assumes no liability of the
customer’s failure to comply with the
requirements.
General
Do not use this products in any manner
not specified by the manufacturer. The
protective features of this product may be
impaired if it is used in a manner not
specified in the operation instructions.
Before Applying Power
Verify that all safety precautions are
taken. Make all connections to the unit
before applying power.
Ground the Instrument
This product is provided with protective
earth terminals. To minimize shock haz-
ard, the instrument must be connected to
the ac power mains through a grounded
power cable, with the ground wire firmly
connected to an electrical ground (safety
ground) at the power outlet. Any interrup-
tion of the protective (grounding) conduc-
tor or disconnection of the protective
earth terminal will cause a potential shock
hazard that could result in personal injury.
Do Not Operate in an
Explosive Atmosphere
Do not operate the instrument in the pres-
ence of flammable gases or fumes.
Do Not Remove the
Instrument Cover
Only qualified, service-trained personal
who are aware of the hazards involved
should remove instrument covers. Always
disconnect the power cable and any exter-
nal circuits before removing the instru-
ment cover.
Do Not Modify the
Instrument
Do not install substitute parts or perform
any unauthorized modification to the
product. Return the product to an Agilent
Sales and Service Office for service and
repair to ensure that safety features are
maintained.
In Case of Damage
Instruments that appear damaged or
defective should be made inoperative and
secured against unintended operation
until they can be repaired by qualified ser-
vice personnel.
Safety Symbols
Waste Electrical and
Electronic Equipment
(WEEE) Directive
2002/96/EC
This product complies with the WEEE
Directive (2002/96/EC) marking require-
ment. The affixed product label (see
above) indicates that you must not dis-
card this electrical/electronic product
in domestic household waste.
Product Category: With reference to the
equipment types in the WEEE directive
Annex 1, this product is classified as a
“Monitoring and Control instrumenta-
tion” product.
To return unwanted products, contact
your local Agilent office, or go to
www.agilent.com/environment/product
for more information.
Technical Support
If you have questions about your ship-
ment, or if you need information about
warranty, service, or technical support,
contact
Agilent Technologies:
In the United States: (800) 829-4444
In Europe: 31 20 547 2111
In Japan: 0120-421-345
Or go to www.agilent.com/find/assist
for information on contacting Agilent in
your country of specific location. You can
also contact your Agilent Technologies
Representative.
Alternating current
Frame or chassis
terminal
Standby supply. Unit is
not completely
disconnected from ac
mains when switch is off
Caution, risk of
electric shock
Caution, refer to
accompanying
ii
To Next Page
Loading...
