Need help?Do you have a question about the Agilent Technologies 7800 ICP-MS and is the answer not in the manual?
General| Type | Inductively Coupled Plasma Mass Spectrometer (ICP-MS) |
|---|---|
| RF Generator Frequency | 27.12 MHz |
| Dynamic Range | 9 orders of magnitude |
| Isotope Ratio Precision | < 0.1% RSD |
| Mass Range | 2-260 amu |
| Sample Introduction | Nebulizer, autosampler compatible |
| Data Acquisition Rate | Up to 10, 000 points per second |
| Interface | Sampler and skimmer cones |
| Software | MassHunter |
| Sample Introduction System | Integrated autosampler |
| Collision/Reaction Cell | Octopole reaction system (ORS3) |
| RF Power | Up to 1600 W |
| Plasma Gas Flow | 15 L/min |
| Auxiliary Gas Flow | Typically 0-2 L/min |
| Nebulizer Gas Flow | 0.6–1.2 L/min |
| Data Acquisition | Pulse counting and analog mode |
| Sample Throughput | High throughput with autosampler |
| Dimensions | Approximately 90 cm (W) x 80 cm (D) x 90 cm (H) |
| Weight | Approximately 150 kg |
| Power Requirements | 200–240 V, 50/60 Hz |
| Detection Limits | Sub-ppt levels |
To Next Page