Hardkey and Softkey Reference ESG Family Signal Generators
Trigger
4-110 User’s Guide
Also, under these conditions, the Trigger key has autorepeat
capability. Hold it down and it will repeatedly trigger the sweep.
This has the effect of stopping the current sweep before it finishes,
when the key repeat is detected.
•The
Trigger Key can start an LF swept-sine output under the following
conditions:
•
Function Generator is selected as the LF Out Source.
•The LF Out Sweep Trigger is set to Trigger Key.
• Swept-sine LF out is selected.
Also, under these conditions, the
Trigger key has autorepeat
capability. Hold it down and it will repeatedly trigger the sweep.
This has the effect of stopping the current sweep before it finishes,
when the key repeat is detected.
• With any of the digital modulation formats configured and turned
on, the
Trigger key can initiate a burst to output a frame or a data
sequence under the following conditions:
• The digital modulation format is configured and turned on.
•The
Pattern Trigger or Frame Trigger softkey in the digital modulation
menu is set to
Trigger Key.
• With a bit error rate test configured and turned on, the
Trigger key
can initiate a bit error rate test under the following conditions:
• The bit error rate test is configured and turned on.
•The
BERT Trigger softkey in the bit error rate test menu is set to
Trigger Key.
To Next Page
Loading...
Need help?
General
