ESG Family Signal Generators Hardkey and Softkey Reference
Sweep/List
User’s Guide 4-103
Load List From Step Sweep
Press this softkey to eliminate the existing sweep list data and replace
it with the step sweep data points. You can only have one sweep list at a
time so be certain that you wish to delete the existing list. You cannot
recover the sweep list data once you press
Load List From Step Sweep.
Softkey Location:
Sweep/List > Configure List Sweep >
Load List From Step Sweep
Load/Store
Pressing this softkey reveals a menu of choices for storing list sweep
data to a file or loading list sweep data from a file into the current
sweep list. In this menu you can also delete existing list sweep files.
Softkey Location:
Sweep/List > Configure List Sweep > Load/Store
Manual Mode Off On
This softkey toggles manual selection of the current sweep point on and
off. When
Manual Mode is On, the selected sweep/list point controls the
frequency and amplitude according to the sweep type. The current point
in the sweep is displayed in the active entry area and also below the
Manual Point softkey. This softkey is disabled when Sweep is set to Off.
Default Value: Off
Softkey Location:
Sweep/List > Manual Mode Off On
Manual Point
Press this softkey to choose a point in the sweep list. When Manual Mode
is
On, the selected sweep/list point controls the frequency and amplitude
according to the sweep type. The current point number is shown in the
active entry area when you press
Manual Point. The frequency of the point
is shown in the frequency area of the display. The amplitude of the
point is shown in the amplitude area of the display. You can choose
which point to sweep using the up and down arrow keys, the front panel
knob, or by entering the point number desired using the numeric
keypad and pressing the
Enter terminator softkey. This softkey is
disabled when
Manual Mode Off On is set to Off.
Default Value: 1
Softkey Location:
Sweep/List > Manual Point
To Next Page
Loading...
Need help?
General
