ESG Family Signal Generators Hardkey and Softkey Reference
Pulse
User’s Guide 4-85
Pulse Width
Use this softkey to change the pulse width for internal pulse
modulation. To change the pulse width, press the softkey once. The
current value for pulse width is displayed in the active entry area. To
enter a new value, rotate the front panel knob until the desired value is
displayed, use the up and down arrow keys, or enter the value using the
numeric keypad and press the
µsec or msec terminator softkey. The
range of values allowed is 8
µ
s to 30 s. Notice that the new value of
pulse width applies only to internal pulse modulation; when external
pulse modulation or internal square pulse modulation is selected, this
softkey is disabled.
Default Value: 40
µ
s
Softkey Location:
Pulse > Pulse Source > Internal Square > Pulse Width
To Next Page
Loading...
Need help?
General
