Agilent Technologies E4980A - Executing Measurement and Data Transfer; Loading and Running the Data Transfer Program; Graph Parameter Selection

4
3. Perform the single trigger measurement with the DUT by pressing Display Format hardkey
> LIST SWEEP softkey > Trigger hardkey
4. Open “E4980A_DataTransfer_xxxx.xls” on the PC. Since this file contains macros, enable
“Macros” to boot the program, then follow the “Step-1” and the “Step-2” in the “Main” sheet.
5. On the newly created sheet, choose the graph parameter to show the graph properly
( X/Y-axis are changed to Log format in the example below)